EPA takes first-ever federal Clean Water Act action

0
270

WASHINGTON — The U.S. Environmental Protection Agency has ordered the Chemours Co. to take corrective measures to address pollution from per-and polyfluoroalkyl substances in stormwater and effluent discharges from the Washington Works facility near Parkersburg.

The order on consent also directs Chemours to characterize the extent of PFAS contamination from discharges.

This is the first EPA Clean Water Act enforcement action ever taken to hold polluters accountable for discharging PFAS into the environment. PFAS are a group of man-made chemicals that have been manufactured and used in industry and consumer products since the 1940s.

There are thousands of different PFAS chemicals, some of which have been more widely used and studied than others.

According to the EPA order, PFAS levels in the discharges from the facility exceed levels that are set in the facility’s Clean Water Act permit.

Under the Clean Water Act, it is unlawful to discharge pollutants into U.S. waterways except pursuant to a National Pollution Discharge Elimination System permit, issued by EPA or a state. The permit sets pollution discharge limits, monitoring and reporting requirements, and other conditions designed to protect water quality. More information on the NPDES program.

Chemours operates several manufacturing units at the Washington Works facility, which produce fluorinated organic chemical products including fluoropolymers. The facility discharges industrial process water and stormwater to the Ohio River and its tributaries, under the terms of a NPDES permit issued in 2018 by the West Virginia Department of Environmental Protection.

E.I. du Pont de Nemours and Company was the NPDES permit holder at Washington Works until 2015. In 2015, the permit was transferred to Chemours.

The permit imposes discharge limits and requires monitoring of certain pollutants, including PFAS such as perfluorooctanoic acid, which was used in the past as a processing aid for manufacturing, and HFPO Dimer Acid, also known as GenX — which replaced PFOA as a processing aid.

In an administrative compliance order on consent, EPA sets forth that this facility exceeded permit effluent limits for PFOA and HFPO Dimer Acid on various dates from September 2018 through March 2023, and that Chemours failed to properly operate and maintain all facilities and systems required for permit compliance.

As an initial step in characterizing PFAS in surface water discharges, EPA’s order requires Chemours to implement an EPA-approved sampling plan to analyze PFAS and conduct analysis to further understand the presence of PFAS in stormwater and effluent discharged from the facility.

Also, Chemours will submit and implement a plan to treat or minimize the discharge of PFAS to ensure compliance with numeric effluent limits of PFOA and HFPO Dimer Acid.

In addition, to identify best practices to reduce PFAS discharges from the site, Chemours will submit its existing Standard Operating Procedures relating to the management of wastewater for various systems and its revised Storm Water Pollution Prevention Plan.

NO COMMENTS

LEAVE A REPLY

We are glad you have chosen to leave a comment. Please keep in mind that comments are moderated according to our comment policy.

Receive emails as this discussion progresses.